![]() The flexibility of the compound slide can rotate on its central pins in both directions because it is fixed on the top of the cross slide. Before clamping, the compound rest should be swiveled to the desired angle. The job rotates along with the lathe axis. Like any other lathe operation, the workpiece is set in the chuck with clamps in this method. To produce a short and steep taper, the compound slide method is the suggested method. Polish the size if you get the desired taper.Arrange the tool as a parallel turning.Until you get the required set over keep adjusting the screws.Slightly detach the clamp of the tailstock.Let’s see the steps of this setting over: Take the reading the set over is perfect if it corresponds.Advance the tool to the right edge of the taper to grip the paper.To grip a piece of paper within the taper surface and tool, move the nose of the tool to the left edge of the taper.How to set a parallel position? These are the steps: Once the turning operation is done, utmost care should be given to set back the tailstock. Instead of degrees, the basis value of the tailstock is offset in mm or inches.Īs the work is mainly at an angle, it should be done between centers. The tool moves in a parallel position with the machine bed. In this method, the machine bed axis is set with an angle where the axis of the job rotates. When there is no available taper attachment, this method is used then.
0 Comments
Leave a Reply. |